EDF Jet

F-16 Fighting Falcon ARF RC Jet

70mm fan + 4 cell lithium battery = BIG fun

30-3/4" wingspan, 48-1/2" long, 35-1/2 oz. flying weight. All molded foam construction with lots of detail and a very smooth finish, painted with matte paint. Total assembly time is about one hour due to the low parts count and beautiful fit. The 70mm fan includes an OUTRUNNER motor that provides lots of thrust for quick takeoffs with a strong climbout. The ducting is very clean giving the F-16 impressive speed, but in a model large enough for easy flight orientation. Battery changes are quick: just remove the canopy (it is held in place with magnets) and swap it out. Access to the 70mm fan unit and 45A ESC is also very simple: just remove 2 screws and the entire middle section of the main duct can be removed. This is great for those who want to hop this one up or simply need easy access for maintenance and blade balancing. The main landing gear are installed without using any tools and only one allen screw installs the nose wheel steering. Model can be flown either off a runway with the included landing gear or it is easily hand launched. Flight times are about 5 minutes using the included 4 cell 2100 mAh LiPo battery. Landings are quite slow due to the large lifting body shape of the F-16. Bring it in with the nose high and it will slow to a walk. Includes 5 pre-installed servos. Requires a 4 channel radio.

item # FMS005

Price $229.95

Airframe Only - includes 70mm fan and landing gear

30-3/4" wingspan, 48-1/2" long. Includes fully decorated airframe with control horns, pushrods, landing gear and drop tanks. 70mm fan unit included. Ready for you to install your servos (requires 5) and the motor, speed control, battery and radio system of your choice.

F-16 Fighting Falcon

Item # FMS005E

Price $129.99

Executive Jet Twin Ducted Fan Jet (Kit only)

Exceptionally well engineered jet, flies smooth and fast - two 66mm fans included

47" wingspan, 53-1/4" long, 370 sq. in. wing area, 47 oz. flying weight. Molded bead foam construction. Fuselage comes with the two 66mm fans pre-installed, ready for the motors and the foam engine nacelles. The wings are reinforced with carbon tubes and have molded recesses for aileron servos; wing tips are made of wood and pre-covered. Molded pockets with plywood mounting blocks for the installation of the landing gear are pre-installed in the wings and accept the included fixed gear or the optional retract gear (SFM3501B). Fuselage has the mount for the steerable nose gear pre-installed; just screw the fixed steerable gear in place. The ailerons, elevator and rudder are made of balsa and covered with heat-shrink film. They are pre-installed and the hinges are pre-pinned for safety. The fuselage has wooden servo mounts and battery tray pre-installed. Jet accelerates quickly and easily takes off from a smooth surface/runway with a strong climb rate. Jet can be hand launched and will belly land easily, without damage when the landing gear is removed. Plastic covers are provided to cover the landing gear openings if you do not install the landing gear. Speed is impressive even with the fixed gear. Flight is smooth and solid; the stall is at a very low speed and is not severe. The glide is amazing; the setup for a landing needs a long approach or you will glide right on by. Flight times with the two 1800 mAh packs in parallel are about 7-10 minutes of varied flying. Assembly is easy and takes about 4-6 hours for the fixed gear version, and about an hour or two more for the retracts. For 4-channels: Aileron (2 servos), Elevator, Rudder/Nose steering, and Throttle. A 5th channel is required if you wish to add the retractable landing gear.

item # SFM290

Price $149

Here's Everything you'll need:

Radio

1 - SPM6600 DX6i Full Range Transmitter, AR6200 Rx, MD2, no servos

2 - HTS055 HS-55 Sub Micro Servo

2 - HTS085MG HS-85 Mighty Micro Plus Metal Gear, Ball Bearing

2 - HT0097 Hitec 12" Servo Extension

1 - HT0096 Hitec Aileron "Y" Connector

Motor/Ducted Fan

2 - MT2235 SFM Outrunner Brushless Motor

Two 66mm Ducted Fan Units included with the airplane.

Motor Controller

2 - SFM2421 SFM 30 Amp Brushless Speed Control

2 - MJ21011 1.8mm Gold Connectors

Battery

2 - PQ18003 Enerland 3 Cell 11.1V 1800mAh Lipo Pack

1 - DEA7001 Parallel Module with Deans Ultra Plugs

Eurofighter Tiger Edition RTF Jet

2 ducted fans, 2 Outrunner Motors, 2 ESC's, One great flying jet

29-1/8" wingspan, 42" long, 350 sq. in. wing area, 30 oz. flying weight. This colorful pre-painted jet has all the main assemblies pre-built. Assembly to flight ready status only takes an hour or two. Two 64mm fans driven by two Outrunner brushless motors power the jet. The two speed controls are 25 amps each and are pre-wired and installed, ready to plug into the supplied 2200 mAh 3-cell lipo battery. Battery access is under the canopy. Canopy is held in place by magnets, as is the upper section behind the canopy, providing access to the speed controls. Fans and motors can be accessed through a removable panel on the bottom of the fuselage. RTF version includes a 4-channel transmitter and a 6-channel receiver. A balance charger for the lithium battery is included. The 3-servos are pre-installed and all control surfaces are pre-hinged with the control horns installed. Jet can be flown with the included landing gear and steerable nose wheel, or the gear can be quickly removed for hand launching and belly landing. Flight times are in excess of 5 minutes. The twin fans provide lots of thrust for strong climbs and a high top speed. Rolls, loops and inverted flight are a breeze and the delta wing really slows down well for soft, slow landings. Photo illustrated building instructions with CG location clearly marked will get you from the box and into the air quickly.

item # JPG007A Type of Build: Ready-To-Fly (RTF)

Price259.99

•Length: 42"

•Wingspan: 29-1/8"

•Flying Weight: 30 oz.

•Controls: Elevons, Nose Wheel Steering, Throttle

F-35 Lightning II w/360 Degree Thrust Vectoring Jet

Thrust Vectoring - Are you ready to tumble?

360 degree thrust vector nozzle allows you to perform maneuvers that have to be seen to be believed. It comes with a 70mm fan and Outrunner brushless motor (2750 Kv), 45 Amp speed control with switch mode BEC, 4-cell 2200 mAh Lipo battery and comes pre-painted. Glue the wings and tails in place and install your 7-channel radio and you are ready to perform the impossible.

The battery and the speed control are pre-connected with genuine Deans Ultra connectors. Retracts with nose wheel steering are pre-installed. Photo illustrated instructions include step-by-step setup of the various mixes on a Spektrum DX-7 radio. Recommended control throws, CG and expo settings are provided.

The F-35 is the most aerobatic EDF jet available. Extreme maneuvers like flat spins, tumbles and high alpha flight are all possible with the 360 degree thrust vectoring nozzle design. If you want to push the envelope of what can be done with a jet, the F-35 is your best choice.

F-35 Lightning II w/360 Degree Thrust Vectoring Jet

Item # HLI3500